|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
5
6
7
8
2. Diagnosis
1 POWER AMP Assy
A
1 2 3 4 5
Remove the Rear Panel. Remove the MAIN Assy (equipped with HDMI&DVC Assy and DSP&USB Assy) and the AUDIO IN Assy from the INTERFACE Assy. Discharge C5721 and C5722. (See the "discharge procedures.") Remove the two screws that fix the Regulators attached to the Chassis. Remove the two Push Rivets and the two screws that fix the POWER AMP Assy. Regulator
9
Remove the Locking Card Spacer from the Chassis using Cutting Pliers.
B
Locking Card Spacer (for fixing the Assy)
9 10 11 12 4 13
Cutting Pliers
Remove the four screws that fix the Heat Sink V5S. Cut the Binder. Remove the four screws that fix the Power Transformer. Place a high insulating material under the Power Transformer to raise it. Raise the block and diagnose the POWER AMP Assy B side.
C
Push Rivet
POWER AMP Assy
DIODE Assy
6
D
POWER AMP Assy
5
Caution: Fix the DIODE Assy to the Rear Panel with Tape so that it will not come closer to other Assy.
Tape DIODE Assy
E
6 7 8
Remove the two screws that fix the diode of the DIODE Assy. Reassembling the MAIN Assy (equipped with HDMI&DVC Assy and DSP&USB Assy) and the AUDIO IN Assy to the INTERFACE Assy. Reassembling the Rear Panel. (Keep a space for earth and about six to seven screws fixing places. Do not attach screws with the Chassis.)
Diagnosis
F
VSX-LX51
5 6 7 8
69
|
|
|
> |
|
