|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
;
It is OK, this manual help me to repair my dynacord
 ;
Good manual. Even it is an old printed manual, it is well scanned and complete, with all drawings, schematics and parts list. Very good return for the cost.
;
I'm very satisfied with my purchase. It resolved my problem. Owner-manuals.com is a very very good place.
Thank you!
;
Veramente completo, dettagliato e perfetto nella visione. Perfect, thanks!
1
2
3
4
Step 6: DIR A
A
Check that the S/PDIF signal is output. Check that changes by pulling out and inserting the digital input lines. IC601 (pin 1) IN1 (OPT: TV/SAT)
IC952 (pin 14) Do convert 3 V into 5 V for pin 6 input? Yes IC952 (pin 13) Do convert 3 V into 5 V for pin 7 input? Yes To Step 5
No Replace IC952.
Can No Check the DIGITAL INPUT Assy, observe the digital signal and parts and patterns in the path. ? (0 V <-> 4 V) Yes IC601 (pin 5) IN2 (OPT: CD-R/TAPE/MD)
B
No
Replace IC952.
Can observe the No Check the DIGITAL INPUT Assy, digital signal and parts and patterns in the path. ? (0 V <-> 4 V) Yes IC601 (pin 44) Can observe the digital signal ? Yes IN3 (COAX: DVD/LD)
Step 5: X'tal
IC802 (pin 2)
C
No
Check the parts and patterns in the path.
(1.65 V center, amplitude more than 0.2 Vp-p) IN4 (COAX: CD)
Is there a 24.576 MHz output? Yes IC802 (pin 7)
No Replace IC802 or X801.
IC601 (pin 42)
Can observe the No Check the parts and patterns digital signal in the path. ? (1.65 V center, amplitude more than 0.2 Vp-p) Yes No Check the path to pin 45 of IC801. Replace IC802. IC601 (pin 27) Is there a master clock output? No Check the path to pin 30 of IC601. Replace IC802. MCKO2 (Master clock) Check that the data and clock signals are output.
Is there a 24.576 MHz output? Yes
D
IC802 (pin 5)
Is there a 24.576 MHz output? Yes To Step 6
Is the No voltage of PDN IC601-pin 31 5 V? (0 V <-> 3.3 V) Check the other assy. (surrounding of the Yes microcomputer) No No Replace IC601.
IC601 (pin 24)
LRCK (LR clock)
E
Is there a LR clock output? Yes
No Replace IC601. (0 V <-> 3.3 V)
B
F
20
1 2
VSX-518-K
3 4
|
|
|
> |
|
