|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
1
2
3
4
8.4 REMOTE CONTROL UNIT
This page describes the buttons on the remote control used to operate the receiver.
A
VSX-55TXi : AXD7325
1 Remote Control Display Screen 2 SOURCE button
Use this button to turn on/off other components. You must input the preset code in order to use this function.
TV
button
This is a dedicated TV button. Use it to turn on/ off your TV.
B
3 MULTI CONTROL buttons
These buttons are the basic controls that switch the mode of the receiver and the remote control, which allows you to control your other components. TV CONT: Press so that the remote control can operate the TV control commands.
CD-R/ TAPE1
MD/ TAPE2
TUN ER
RECEIVER
4 Number buttons
These can be used for many purposes depending on the mode of the remote control. When in receiver mode the buttons operate as below:
C
DIMMER button
Use to adjust the brightness of the receiver's display.
LOUDNESS button
Switches the LOUDNESS mode on or off.
TONE button
This button switches between TONE on and off, which bypasses the tone circuitry.
BASS/TREBLE buttons
D
Use to select whether the bass or treble will be adjusted.
(+/�) buttons
Use to adjust the TONE level, effect level, channel level and sound delay as well as make Dolby Pro Logic II MUSIC parameter settings.
EFFECT/CH SEL button
Switches between the different channels so you can add volume individually to each channel with the + and � buttons. Also selects EFFECT mode, Dolby Pro Logic II MUSIC parameters and sound delay settings. You can then use the + and ñ buttons to make these adjustments.
E
SIGNAL SEL button
Press repeatedly to select one of the following: AUTO � If there are analog and digital signals input, the receiver automatically selects the digital signal. DIGITAL � To select an optical or coaxial digital signal. ANALOG � To select an analog signal.
F
180
1 2
VSX-55TXi
3 4
|
|
|
> |
|
