|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
1
2
3
4
8.4 REMOTE CONTROL UNIT
This page describes the buttons on the remote control used to operate the receiver.
A
VSX-55TXi : AXD7325
1 Remote Control Display Screen 2 SOURCE button
Use this button to turn on/off other components. You must input the preset code in order to use this function.
TV
button
This is a dedicated TV button. Use it to turn on/ off your TV.
B
3 MULTI CONTROL buttons
These buttons are the basic controls that switch the mode of the receiver and the remote control, which allows you to control your other components. TV CONT: Press so that the remote control can operate the TV control commands.
CD-R/ TAPE1
MD/ TAPE2
TUN ER
RECEIVER
4 Number buttons
These can be used for many purposes depending on the mode of the remote control. When in receiver mode the buttons operate as below:
C
DIMMER button
Use to adjust the brightness of the receiver's display.
LOUDNESS button
Switches the LOUDNESS mode on or off.
TONE button
This button switches between TONE on and off, which bypasses the tone circuitry.
BASS/TREBLE buttons
D
Use to select whether the bass or treble will be adjusted.
(+/�) buttons
Use to adjust the TONE level, effect level, channel level and sound delay as well as make Dolby Pro Logic II MUSIC parameter settings.
EFFECT/CH SEL button
Switches between the different channels so you can add volume individually to each channel with the + and � buttons. Also selects EFFECT mode, Dolby Pro Logic II MUSIC parameters and sound delay settings. You can then use the + and ñ buttons to make these adjustments.
E
SIGNAL SEL button
Press repeatedly to select one of the following: AUTO � If there are analog and digital signals input, the receiver automatically selects the digital signal. DIGITAL � To select an optical or coaxial digital signal. ANALOG � To select an analog signal.
F
180
1 2
VSX-55TXi
3 4
|
|
|
> |
|
