|
|
|
Who's Online
There currently are 5972 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
VSX-808RDS
% SIGNAL SELECT button
Use to select input signals for the digital components. First press DVD/LD, TV/SAT, MD/TAPE 1, CD or VCR 1 (+, Function buttons) to select the component, then press SIGNAL SELECT repeatedly to select one of the following: ANALOG : Selects the analog (R and L) audio signals. DIGITAL : Selects the digital audio signals. This receiver automatically detects and displays the format of the signal being input. AC-3 lights when Dolby Digital signals are input, DTS lights when DTS signals are input, and MPEG lights when MPEG signals are input. (AC-3 and DTS decoding is switched automatically.) � SIGNAL SELECT is fixed in the �ANALOG� position for components not assigned to one of the four digital input jacks. � Because the audio from a karaoke microphone and LD recorded with analog audio only is not output from the digital output, set SIGNAL SELECT to �ANALOG�. � This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and 48kHz), DTS, and MPEG digital signal formats. With digital signal formats other than these, set SIGNAL SELECT to �ANALOG�.
^ DSP MODE button
Press repeatedly to select a DSP sound mode (HALL 1, HALL 2, JAZZ, DANCE, THEATER 1, or THEATER 2). Use these modes to produce surround sound from standard (two channel) stereo sources.
& MIDNIGHT button
Press to hear effective surround sound at low volume levels. The effect is automatically adjusted according to the volume level.
* DIGITAL NR button
Switches DIGITAL NR on or off. Use to reduce noise in digital audio sources.
( MASTER VOLUME
After turning on the desired component, rotate to adjust the volume.
) PHONES jack
Connect headphones for private listening (the speakers turn off automatically).
_ STATION/FREQUENCY (+/�) button
STATION: Press to select the preset channel. FREQUENCY: Press to select the frequency.
+ Function buttons
Selects the function. Each press switches the DVD/LD input between DVD/LD and DVD 5.1 channel.
¡ TAPE 2 MONITOR button
Switches the TAPE 2 monitor on or off.
� VIDEO INPUT jacks
Connect a video camera, video game system, etc. to the VIDEO INPUT jacks.
58
|
|
|
> |
|
