|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service and prompt delivery. But it's not a manual - only 4 pages wiring diagrams.
Thanks.
 ;
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
;
Il download del Service Manual JVC HR 4100 non é stato eseguito
;
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
;
Very fast, clear and usefull site !
Also this Service Manual are very well maked and with a very good definition !
Very fast download speed !
Recomended Seller !
5
6
7
8
A M
IC152 (pins 2, 5) DDC_RX1
Q
IC101 (pins 58, 59, 62, 63, 66, 67, 70, 71) TMDS_RX2
A
Are signals detected?
No
Check the soldering of CN101. If soldering has not been done correctly, replace CN101.
Do signals (approx. 0.5 Vp-p) run in all the lines?
No
Check the soldering of CN102. If soldering has not been done correctly, replace CN102.
M
Yes
IC152 (pins 3, 6) Are signals the same as those at Pins 2 and 5 detected ? N Yes Q153 (pins 1, 4) Are signals the same as those at Pins No 6 and 3 but whose voltage has been converted from 5V to 3V detected? Yes
R
Yes DDC_RX2 No Check the soldering of CN102. If soldering has not been done correctly, replace CN102.
B
IC172 (pins 2, 5) No Check the soldering of IC152. If soldering has not been done correctly, replace IC152.
Are signals detected?
R
Yes
IC172 (pins 3, 6) Are signals the same as those at Pins 2 and 5 detected ? Check the soldering of IC172. If soldering has not been done correctly, replace IC172.
C
Check the soldering of Q153. If soldering has not been done correctly, replace Q153.
No
S
Yes
O
IC161 (pins 2, 15) Are signals the same as those at Pins 3 and 13 detected immediately after the power is turned on? Yes IC151 (pin 8) No Check the soldering of D151. If soldering has not been done correctly, replace D151.
Q173 (pins 1, 4) Are signals the same as those at Pins 6 and 3 but whose voltage has been converted from 5V to 3V detected? Yes
No
No Check the soldering of IC161. If soldering has not been done correctly, replace IC161.
Check the soldering of Q173. If soldering has not been done correctly, replace Q173.
P
O
IC161 (pins 4, 11)
D
Is the voltage about 5V? Yes
Are signals the same as those at Pins 3 and 13 detected immediately after the power is turned on?
No Check the soldering of IC161. If soldering has not been done correctly, replace IC161.
Check the soldering of IC151. If soldering has not been done correctly, replace IC151.
T
Yes IC171 (pin 8)
Is the voltage about 5V? Yes Replace IC171
No
Check the soldering of D171. If soldering has not been done correctly, replace D171.
E
F
VSX-AX4AVi-S
5 6 7 8
213
|
|
|
> |
|
