|
There are currently no product reviews.
 ;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
5
6
7
8
A M
IC152 (pins 2, 5) DDC_RX1
Q
IC101 (pins 58, 59, 62, 63, 66, 67, 70, 71) TMDS_RX2
A
Are signals detected?
No
Check the soldering of CN101. If soldering has not been done correctly, replace CN101.
Do signals (approx. 0.5 Vp-p) run in all the lines?
No
Check the soldering of CN102. If soldering has not been done correctly, replace CN102.
M
Yes
IC152 (pins 3, 6) Are signals the same as those at Pins 2 and 5 detected ? N Yes Q153 (pins 1, 4) Are signals the same as those at Pins No 6 and 3 but whose voltage has been converted from 5V to 3V detected? Yes
R
Yes DDC_RX2 No Check the soldering of CN102. If soldering has not been done correctly, replace CN102.
B
IC172 (pins 2, 5) No Check the soldering of IC152. If soldering has not been done correctly, replace IC152.
Are signals detected?
R
Yes
IC172 (pins 3, 6) Are signals the same as those at Pins 2 and 5 detected ? Check the soldering of IC172. If soldering has not been done correctly, replace IC172.
C
Check the soldering of Q153. If soldering has not been done correctly, replace Q153.
No
S
Yes
O
IC161 (pins 2, 15) Are signals the same as those at Pins 3 and 13 detected immediately after the power is turned on? Yes IC151 (pin 8) No Check the soldering of D151. If soldering has not been done correctly, replace D151.
Q173 (pins 1, 4) Are signals the same as those at Pins 6 and 3 but whose voltage has been converted from 5V to 3V detected? Yes
No
No Check the soldering of IC161. If soldering has not been done correctly, replace IC161.
Check the soldering of Q173. If soldering has not been done correctly, replace Q173.
P
O
IC161 (pins 4, 11)
D
Is the voltage about 5V? Yes
Are signals the same as those at Pins 3 and 13 detected immediately after the power is turned on?
No Check the soldering of IC161. If soldering has not been done correctly, replace IC161.
Check the soldering of IC151. If soldering has not been done correctly, replace IC151.
T
Yes IC171 (pin 8)
Is the voltage about 5V? Yes Replace IC171
No
Check the soldering of D171. If soldering has not been done correctly, replace D171.
E
F
VSX-AX4AVi-S
5 6 7 8
213
|
