|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
Setting up the receiver
06
We recommend setting this to 200Hz if your S speakers are smaller bookshelf-type speakers. � Use or to specify the crossover frequency for your small speakers (100 Hz, 150 Hz or 200 Hz).
� Use or to set the attenuation level (0 dB, 10 dB or dB(�)).
0 dB
10 dB )
� (displays
100Hz
150Hz
200Hz
100Hz Sends bass frequencies below 100 Hz to the subwoofer (or L speakers). 150Hz Sends bass frequencies below 150 Hz to the subwoofer (or L speakers). 200Hz Sends bass frequencies below 200 Hz to the subwoofer (or L speakers).
� When � is selected ( appears in the display), LFE cannot be heard.
Front left speaker distance setting
� Default setting: 10 ft. Sets the distance from the front left speaker to the listening position. � Use or to set the distance of the front left speaker from the main listening position (within the range of 0.5 ft. to 45 ft.).
Center speaker distance setting
� If all speakers (front, center, and surround) are set to L, the crossover frequency can�t be set because there are no S speakers ( appears in the display). � Default setting: 10 ft. The center speaker is normally placed directly in the front of the listening room and closer to the listening position than the front speakers. This means that the sound from the center speaker will be heard before the front speakers. To prevent this, set the center speaker distance setting to delay the sound from the center speaker so that the sound from the front and center speakers will be heard at the same time.
LFE attenuator setting
� Default setting: 0 dB Dolby Digital and DTS audio sources include ultra-low bass tones. Set the LFE attenuator as necessary to prevent the ultra-low bass tones from distorting the sound from the speakers.
47
En
|
|
|
> |
|
