|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
5
6
7
8
The following DVR controls can be accessed by pressing SHIFT: ¶ REC Starts recording. REC STOP Stops recording. HDD/DVD These buttons switch between the hard disk and DVD controls for DVD/HDD recorders. 9 RECEIVER CONTROL buttons STANDARD Press for Standard decoding and to switch between the various Pro Logic IIx and Neo:6 options). ADV. SURR. Use to switch between the various surround modes. STEREO Switches between direct and stereo playback. Direct playback bypasses the tone controls and channel levels for the most accurate reproduction of a source. SLEEP Use to put the receiver in sleep mode and select the amount of time before the receiver turns off. MIDNIGHT/LOUDNESS Switches to Midnight or Loudness listening. TEST TONE Sounds the test tone when setting up the surround sound of the receiver. CH SELECT Selects a speaker when setting up the surround sound of the receiver.
LEVEL +/� Adjusts the levels of the surround sound of the receiver. EFFECT +/� Adds or subtracts the amount of effect with different advanced surround modes. 10 SHIFT Press to access the DVR controls above the component control butttons. 11 SOURCE Press to turn on/off other components connected to the receiver. 12 Character display (LCD) This display shows preset codes and other information when transmitting control signals. The following commands are shown when you�re setting the remote to control other components (see Controlling the rest of your system): SETUP Indicates the setup mode, from which you choose the options below. PRESET See Selecting preset codes directly. LEARN (VSX-D914 model only) See Programming signals from other remote controls. DIRECT F See Direct function. ERASE (VSX-D914 model only) See Erasing one of the remote control button settings. RESET See Erasing all of the remote control presets. READ ID See Confirming preset codes. 13 RECEIVER Switches the remote to control the receiver (used to select the features above the number buttons (INPUT ATT, etc). Also use this button to set up surround sound. 14 MASTER VOLUME +/� Use to set the listening volume.
A
B
C
D
E
F
VSX-D914-K
5 6 7 8
83
|
|
|
> |
|
