|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
 ;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
;
This comprehesive service maual was greatly appreciated, as was the digital download.
5
6
7
8
Step 7: 1st DSP f
CN401 (Pin 20) RESET
j
CN401 (Pin 16)
For the following diagnosis, a digital oscilloscope must be used. SPICLK
A
Is the logic of RST_1 "H" ?
No
Check the output from the DIGITAL MOTHER Assy.
w
Yes R139
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the output from the DIGITAL MOTHER Assy.
y
Yes R144
Is the logic of RST_1 "H" ? Yes
No
Check the resistors and patterns in the path.
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the resistors and patterns in the path.
B
Is the logic of RST_1 maintained at "H"? (Does it fall to become "L" periodically?)
k
No It is likely a boot error. (It is very difficult to diagnose which peripheral part of the DSP is in failure.)
Yes CN401 (Pin 19) MOSI
g
Yes R134 REQ_1
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the output from the DIGITAL MOTHER Assy.
C
z
Does the logic become "H" for a moment when the input stream is changed? No The 1st DSP is in failure. Replace it.
Yes R146
g
Yes CN401 (Pin 21)
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the resistors and patterns in the path.
AA
Does the logic become "H" for a moment when the input stream is changed? No Check the resistors and patterns in the path.
Yes R142 MISO
h
Yes CN401 (Pin 17) SPIDS_1
Is the clock signal output while the voltage at SPIDS_1 is "L"?
D
No The 1st DSP is in failure. Replace it.
i
Does the logic become "L" for a moment when the input stream is changed? No Check the output from the DIGITAL MOTHER Assy.
Yes CN401 (Pin 18)
x
Yes R137
Is the clock signal output while the voltage at SPIDS_1 is "L"? Yes
No
Check the resistors and patterns in the path.
E
Does the logic become "L" for a moment when the input stream is changed? Yes
No
Check the resistors and patterns in the path.
It is very difficult to diagnose which part is in failure.
F
VSX-LX70
5 6 7 8
35
|
|
|
> |
|
