|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
5
6
7
8
Step 7: 1st DSP f
CN401 (Pin 20) RESET
j
CN401 (Pin 16)
For the following diagnosis, a digital oscilloscope must be used. SPICLK
A
Is the logic of RST_1 "H" ?
No
Check the output from the DIGITAL MOTHER Assy.
w
Yes R139
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the output from the DIGITAL MOTHER Assy.
y
Yes R144
Is the logic of RST_1 "H" ? Yes
No
Check the resistors and patterns in the path.
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the resistors and patterns in the path.
B
Is the logic of RST_1 maintained at "H"? (Does it fall to become "L" periodically?)
k
No It is likely a boot error. (It is very difficult to diagnose which peripheral part of the DSP is in failure.)
Yes CN401 (Pin 19) MOSI
g
Yes R134 REQ_1
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the output from the DIGITAL MOTHER Assy.
C
z
Does the logic become "H" for a moment when the input stream is changed? No The 1st DSP is in failure. Replace it.
Yes R146
g
Yes CN401 (Pin 21)
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the resistors and patterns in the path.
AA
Does the logic become "H" for a moment when the input stream is changed? No Check the resistors and patterns in the path.
Yes R142 MISO
h
Yes CN401 (Pin 17) SPIDS_1
Is the clock signal output while the voltage at SPIDS_1 is "L"?
D
No The 1st DSP is in failure. Replace it.
i
Does the logic become "L" for a moment when the input stream is changed? No Check the output from the DIGITAL MOTHER Assy.
Yes CN401 (Pin 18)
x
Yes R137
Is the clock signal output while the voltage at SPIDS_1 is "L"? Yes
No
Check the resistors and patterns in the path.
E
Does the logic become "L" for a moment when the input stream is changed? Yes
No
Check the resistors and patterns in the path.
It is very difficult to diagnose which part is in failure.
F
VSX-LX70
5 6 7 8
35
|
|
|
> |
|
