Connections/ Initial Setup (Ready to Play)
Please make all cable or antenna connections before plugging into the AC outlet. Plugging the unit power cord into an AC outlet How to Connect starts auto channel and clock set.
Connecting
For ANT./Cable Connect the cable from Antenna/Cable to the VHF/UHF terminal on the unit.
UNIT
VHF/UHF
IN from ANT./CABLE
VHF/UHF
VHF/UHF
For DSS/Cable Box Connect the OUT jack on your cable box to the VHF/UHF terminal on the unit with a RF cable.
WARNING:
Overtightening �Nut type� RF coaxial cables may damage jacks. Finger tighten only.
Cable TV Converter Box
VHF/UHF
VHF/UHF
IN from ANT./CABLE
Initial Setup (Plug&Play) Initial Setup (Ready to Play)
1 2
Plug the unit power cord into an AC wall outlet. Press POWER on the remote or unit. The unit comes on and auto channel and clock set starts.
3
Settings are made automatically. When setup is done, this screen appears.
2 / 6 / 2002 WED 12 : 00PM
DST : ON SETT I NG : CH 1 0 AUTO CLOCK SET COMPLETED
CH AUTO SET PROCEEDING
� If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS reciever, it must be turned off.
If AUTO CLOCK SET IS INCOMPLETE screen appears, set the clock using MANUAL CLOCK SET procedure on next page.
AUTO CLOCK SET
AUTO CLOCK SET PROCEEDING CANCEL : PRESS STOP KEY
I S I NCOMPLETE PLEASE SET CLOCK BY PRESS I NG ACT I ON KEY
8
Forassistance,pleasecall:1-800-211-PANA(7262)orsende-mailto:
[email protected]
