|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
PLAYBACK
Playback
This section explains the basic playback operation. Preparation � Select the video channel (3 or 4) or video input mode on the TV. � Press VCR to set the remote control operating the VCR.
VCR
1 4 7 2 5 8 0 3 6 9
100
Basic Playback
CH/TRK
1
Load a recorded cassette.
POWER
Power is turned on. If the cassette has no safety tab, playback starts automatically.
PLAY/x2
2
FF
2 3
Press PLAY/x2 to start playback.
POWER S P VCR
DT
REW
FF
STOP
3 19µ
REW
To stop playback, press STOP.
Rewinding / Fast-forwarding Press REW or FF in the stop mode.
Adjusting the tracking
When playback starts, the VCR automatically adjusts the tracking for clear pictures and sound (Digital Auto Tracking). The �DT� indicator blinks during the adjusting. If the VCR cannot locate the best possible tracking point, hold down one of CH/TRK to adjust the tracking manually. � To resume the digital auto tracking, hold down both CHANNEL on the VCR simultaneously for about 2 seconds.
Notes � During the adjusting, the playback picture and sound may be distorted. � The digital auto tracking is activated only in the playback mode. � To reset the manual tracking point to the center, press both CHANNEL on the VCR simultaneously for not longer than 1 second. � The noise on the screen may not be completely eliminated depending on the tape used, especially when the tape was recorded on another VCR.
19µ HEAD
You can view high quality pictures while playing back a tape recorded in the SLP tape speed. By pressing 19µ repeatedly, the 19µ HEAD mode is displayed on the TV screen as follows: 19U-HEAD AUTO: Usually set to �AUTO�. As the playback starts, the VCR automatically activates the 19µ head and reproduces high quality pictures. 19U-HEAD OFF: Set to �OFF� if the pictures are marred by dots.
Note During playback with the 19µ head, momentary noises or shakes may be produced when you change the mode to the picture search or variable speed playback.
20
|
|
|
> |
|
