|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Well-scanned, complete manual. Contains the information needed for repair and maintenance.
;
It's great to be able to obtain a precious technical information for a real old equipment. The one I got helps me a lot in the area of wiring diagram to repair my antique. PDF gave me clear enough information to find out thr details. Thanks for giving me the oppotunity to be able to access to almost vanished informations.
;
Another excellent aquisition. Fine detailed manual. Thanks
 ;
Good quality for the scan, complete, but as usual for Tascam, not so comprehensive !
;
great manual readable & easy to downlaod to be recommanded
Disassembly and Reassembly
4-3-26 Damper Capstan, Motor Capstan Ass�y Removal
1) Remove the Damper Capstan � in the direction of arrow. 2) Remove the 3 Screws ´. 3) Remove the Motor Capstan Ass�y �. Assembly : 1) Match the 3 holes of Motor Capstan Ass�y � to the 3 holes of Main Base. Be careful not to drop or knock the Motor Capstan Ass'y �. 2) Tighten the 3 Screws ´ in the direction of arrow as shown detail drawing. 3) Assemble the Damper Capstan �. Note : After tightening screws, check if there is gap between the head of screws and the top side of Main Base. There should have no gap between the head of screws and the top side of Main Base. After reinstalling, adjusting the tape transport system again.
´ 3 SCREWS
4-3-27 How to Eject the Cassette Tape (If the unit does not operate on condition that is inserted into housing ass�y)
1) Turn the Gear worm � clockwise with screw driver.(Refer to arrow) (Other method : Remove the Screw of Motor Load Ass'y, Separate the Motor Load Ass'y)
� GEAR WORM
A
B
Fig. 4-37
C
� DAMPER CAPSTAN
2) When Slider S,T are approched in the position of unloading, rotate holder Clutch counterclockwise after inserting screw driver in the hole of frame's bottom in order to wind the unwinded tape. (Refer to Fig. 4-38) (If you rotate Gear Worm � continuously when tape is in state of unwinding, you may cause a tape contamination by grease and tape damage. Be sure to wind the unwinded tape in the state of set horizently.) 3) Rotate Gear Worm � clockwise using screw driver again up to the state of eject mode and then pick out the tape.(Refer to Fig. 4-37)
� MOTOR CAPSTAN ASS'Y
Fig. 4-36 Damper Capstan,Motor Capstan Ass�y Removal
FRAME
Fig. 4-38 4-18 Toshiba
|
|
|
> |
|
