|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
 ;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
Troubleshooting Guide (valid for all �LCD Intelligent Dialogue WAL.....� models)
Depending on the model, your washing machine is equipped with various automatic safety functions. This enables faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes. � the washing machine has a safety hose and the safety valve is open (red indicator in the safety valve inspection window); In this case replace it with a new safety hose Reconnect the appliance to the electrical socket. Switch the washing machine on and restart the desired programme (do not add any more detergent).
Final spin results are poor:
Check whether the notice �Load Imbalance!� or �Excessive Foam!� appears on the display. The washing machine has an unbalance detection and correction system. If individual heavy items are loaded (e.g. a bathmat or bathrobe), this system may reduce the spin speed automatically or even interrupt the spin completely if it detects too great an imbalance even after several spin starts, in order to protect the washing machine � if the laundry is still too wet at the end of the cycle, add smaller articles of laundry and repeat the spin cycle � excessive foam formation may prevent spinning. Observe correct detergent dosages Check whether: � spin speed �0� has been selected
The appliance will not start, no display is visible.
Check whether: � the mains plug is inserted into the socket � the wall socket is functioning correctly (use a table lamp or similar) to test � the �On/Off� button has been pressed and the washing machine is switched on
The washing machine stops during the programme and the �Start� light flashes.
Check whether: � �Rinse Hold Selected� appears in the display � the door has been opened. Close the door Press the �Start� button to continue with the programme
The washing machine will not start and the �Start� light is flashing.
The notice �Door Open!� appears in the display: � close the door (child safety)
Detergent and additive product residues in dispenser at end of wash.
Check whether: � the siphon is correctly installed and clean (see �Care And Maintenance�) � sufficient water is entering. The mesh filters could be clogged (see Care And Maintenance/Mesh Filters in the Water Connection) � when using powder detergent beforehand the coloured insert for dosing liquid detergent has been removed from the dispenser
The washing machine stops shortly after the programme start.
The message �No Water Supply!� appears on the display. Switch the washing machine off, pull out the mains plug and check whether: � the tap is fully turned on � the water supply pressure is sufficient � the water inlet hose is kinked � the mesh filters are blocked (see �Care And Maintenance�/ �Mesh Filters in the Water Connection�) � the water in the inlet hose is frozen
The washing machine vibrates during the spin cycle.
Check whether: � the washing machine is level and standing firmly on all four feet � the transport bolts have been removed. Before using the machine, it is imperative that the transport bolts are removed
18
|
|
|
> |
|
