|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It's complete and helpful manual with good quality of scan. Thanks very much.
 ;
The service was quick and simple, finding the service manual easy and it appears to be the original with colour schematics. It contained the info I was after and so sorted the problem.
I have copied it to CD and attached the envelope to the inside back cover of the owners manual. Good manual and excelent service. Robin Wood, Wood Electronics, New Zealand.
 ;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
 ;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
MODELS: WD-52627 / 52628 / 62627 / 62628 / 62827 / 62927 / 73727 / 73827 / 73927
DIAMOND SHIELD REPLACEMENT
(WD-62927 / WD-73927 Only)
To Remove the Diamond Shield: 1) While wearing soft cotton gloves, loosen the sides of the Diamond Shield by pressing a small plastic card (the size of a standard credit card or a clean, plastic, putty knife) into the middle of the side slot. The Diamond Shield side will snap out of the top, middle and bottom clips. Loosen both sides before proceeding to step 2. 2) After the sides are free, gently push down on the top of the Diamond Shield. It will slide out of the top channel. 3) Carefully pull the screen up to it from the bottom channel. Store the Diamond Shield in a clean dust free area, where it will not be scratched.
To Install the Diamond Shield: 4) Slide the Diamond Shield into the bottom channel, making sure it fits securely. 5) Press gently on the top of the Diamond Shield to slightly bow the screen toward you. Insert the top of the Diamond Shield into the top channel. It should fit securely. 6) At each side, gently press the top, middel and bottom of the Diamond Shield to snap it back into place.
WARNING
Sharp edges! Always wear gloves to handle, lift, install and remove the Diamond Shield.
Page 38
|
|
 |
> |
|