|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
;
Excellent quality, very quick download turnaround, will definately use again.
MODELS: WD-52627 / 52628 / 62627 / 62628 / 62827 / 62927 / 73727 / 73827 / 73927
WD-73927
1) Remove (16) screws (A). 8 on each side. (Remove only the outside screws. Do not remove inside screws, they are for the Screen Frame) 2) Pull Front Panel Escushions from unit.
A
A
A
A
3) Remove (8) screws (B) and remove the Pedestal Cover. Mechanical adjuster is now accessable.
B
B
Locking Screws and Wedge Removal
Before mechanical adjustments can be made, locking screws must be loosened.
� �
[B-1] is located on the front of the UNIT-ADJUSTER. (Figure 1) In 52� and 62� models [B-2] is accessible from the rear of the unit on the right side of the Optical Engine (from the rear). (Figure 2) WARNING: DO NOT loosen [B-2] too far. The nut on the other side may drop off. Then then Optical Engine must be removed to re-install the nut.
[B-2]
Figure 2: 52� & 62� Side Locking Screw
Page 49
|
|
|
> |
|
