|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
s Rear View
<WJ-FS116>
16 IN
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
SIGNAL GND
ALARM/REMOTE OUT 16 15 14 13 12 11 10 9 8 VIDEO 7 6 5 4 3 2 1 PLAY IN REC OUT MONITOR OUT
CAMERA SW IN
<WJ-FS109>
9 IN
8
7
6
5
4
3
2
1
SIGNAL GND
ALARM/REMOTE OUT 9 8 7 6 VIDEO 5 4 3 2 1 PLAY IN REC OUT MONITOR OUT
CAMERA SW IN
q Video Input Connectors (VIDEO IN)
These connectors accept a composite video signal from a camera. Note: If the input signals have a high jitter content, as in the case of a VTR playback picture, it may not be possible to synchronize this unit.
y Monitor Output Connector (MONITOR OUT)
The video output signal for the monitor is provided via this connector.
u Camera Switching Input Connector (CAMERA SW IN)
The camera switching pulse from the time lapse VTR is supplied to this connector. The camera switching interval (Sequential Dwell Time) can be synchronized with the time lapse mode set in the associated time lapse VTR.
w Video Output Connectors (VIDEO OUT)
The video signals connected to the Video Input Connectors (VIDEO IN) are looped through to these connectors with an automatic 75 � termination.
e Alarm / Remote Control Connector (ALARM / REMOTE)
This connector accepts the alarm signals from the associated alarm sensor units and the control signals from the external system.
i Signal Ground Terminal (SIGNAL GND) o Power Cord
r Playback Input Connector (PLAY IN)
The playback signal from the time lapse VTR is supplied to this connector.
t Record Output Connector (REC OUT)
The recording signal for the time lapse VTR is provided via this connector.
�3�
|
|
|
> |
|
