|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
INSTALLATIONS
Rack Mounting
The encoder and the decoder can be installed in the following racks. � Racks equivalent to EIA standard: Type 19" EIA standard (depth: more than 450 mm (17-11/16"))
Blank panel (1U)
This unit
A device that generates heat such as a power amplifier This unit
Important � Do not install the encoder and the decoder above an appliance which generates heat such a power amplifier. When installing the encoder and the decoder below a heat-generating appliance, install them below the appliance with a space equivalent to about 1 unit separating them. � Keep the temperature in the rack below +45 °C (113 °F). � When the rack is in a place subject to vibrations, fix the rear of the encoder and the decoder with reinforcing brackets (not included) � Fix the provided tapping screws into screw holes of the rack that have never been threaded before. When screwing a tapping screw into a threaded screw hole, thread ridge of the screw hole may be damaged.
Mounting the decoder
1. Remove the four rubber feet by removing the four screws from the bottom of the decoder.
2. Place the supplied rack mounting brackets on both sides of the decoder and tighten with the four supplied screws (M3x8).
Fixing screws (M3x8) (supplied)
Rubber feet
Top
3. Install the decoder with the rack mounting brackets in the rack by using four screws (not included).
Rack mounting brackets (supplied)
Fixing screws (M3x8) (supplied)
Rack mounting screws
28
|
|
|
> |
|
