|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Delivery came quite promptly and in a very readable format. Thank you.
;
I found my Clarion VRX8370R in the Camper I bought and I wasn't able for month to understand it.
The Owner Manual was perfect and just what I was searching for.
Thank you.
Leonardo
;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
;
Zeer duidelijke afdrukken op A4-formaat , zeer uitgebreide handleiding . Pluspunt ,zeer snelle
respons van jullie , binnen de 24h . Top !!!
;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
7.
Place the brackets with the fixed HDDs into the unit and fix them using the four screws removed in step 3. � Do not use an electric screwdriver to fix them. Recommended tightening torque = 0.784 N · m {8 kgf · cm}
11. Attach the front cover as it was.
11-1 Align both the left edges of the front cover and the unit, and then push the front cover onto the unit. 11-2 Slide the front cover to the right.
8.
Connect the cables.
Note: The front cover may be attached and detached as necessary in the next step 12. Be careful not to damage the harness.
12. Turn on the power of the system to reconstruct the system. See the table on the next page to perform start-up procedures. Note that step 1 in the next page depends on how you have cut the motor power in case 1 or 2 mentioned in page 9.
9.
Attach the metal plate removed in step 2 with the six screws (marked with �) previously removed. Take the steps in order depending on the cases A, B, C, and D. Case A: Extension units not configured yet and newly installed or added to be run in SINGLE or RAID5 mode. Case B: Extension units already configured in SINGLE mode and having HDD added, removed, or replaced. Case C: Extension units already configured in RAID5 mode having HDD added or removed. Case D: Extension units already configured in RAID5 mode having replaced HDD.
10. Connect the detached harness as it was.
Important: Turn the units on in the following order. The extension units need to be turned on first and the digital disk recorder is the last. Note: The digital disk recorder will need about three to five minutes to complete the system check that is started as it is turned on. The time length depends on the connections and number of the extension units.
11
|
|
|
> |
|
