|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
 ;
Great to be able to set channels again, on an old but stoll fine working TV
Board Mounting Procedure
The following example is the procedure to mount a network board into the OUT X-1 slot of WJ-SX650 Series. Notes: � This network board can be inserted into the OUT X-1 slot only. � Before the procedure, power off WJ-SX650 Series. � Remove the screws and fixing brackets surely when dismounting. � Fix the screws surely when mounting. � Do not hit the boards against the chassis of WJ-SX650 Series.
Video Video Outp Outp
4. Mount the network board into the OUT X-1 slot, and fix the board with the supplied screws.
D SIGNAL GN
SIGNAL GN
D
3 DATA 4 NL7 DATA HDR3/TMNL3 NL8 4/TM 1/TM 2 HDR NL4 HDR ut Board 2/TM 1 HDR ut Board
TERM.O
FF ON
TERM.O MODE
N
DATA 1 2 DATA L6 TMN L2 TMN TMN L5 DATA
MODE
TMNL1/PS
1. Remove the front panel by loosening the screws.
Network board
5. Mount the video output main board by hooking the board stoppers on the board stopper angles at the front side, by pushing down the board stoppers, and by fixing the screws. Then, attach the front panel.
OPER ATE
Matrix Sw
itcher
WJ-SX
6
50
2. Dismount the video output main board from the front side.
Board stopper angle Board stopper Hook the board stoppers on the board stopper angles, and push down the board stoppers.
Fixing brackets (x4) Screws (x8) � Mount the main board into the slot. � Fix the board with the screws (x3). � Attach the fixing brackets (x4) with the screws (x8).
Video output main board Fixing brackets (x4) Screws (x8)
Note: When mounting, insert the main board surely into slits.
3. Dismount the OUT X-1 board from the rear side.
SIGNAL
GND
L GND SIGNA
FF ON TERM.O
N TERM.O MODE
DATA 1 DATA 3 DATA 4 L7 DATA HDR3/TMNL3 L8 /TMN /TMN 2 HDR4 L4 HDR1 t Board HDR2/TMN 1 t Board TMNL TMNL 2 6 2 5 TMNL DATA
MODE
TMNL1/PS
OUT X-1 board
Video Video
Outpu Outpu
Fixing brackets (x2) Screws (x2)
3
|
|
|
> |
|
