|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
q Setting Up Preset Positions
In the PRESET PROGRAM menu, select SET UP PRESET, and then press the CAM (SET) key. The PRESET NUMBER SET table shown below appears on the active monitor.
5. Move the cursor to the area, where backlight is bright, by moving the Joystick Controller. 6. Press the INC +1CAM button or DEC �1CAM button to toggle a mask on and off. 7. Repeat the above procedures until mask setting is completed.
CAM
: CameraTitle
*PRESET NUMBER SET* 1# 2# 3# 4# 5# 6# 7# 8# 9# 10# 11# 12# 13# 14# 15#H 16# 17 18 19 20# 21 22 23 24 25 26 27 28 29 30 31 32
8. Press the CAM (SET) key to execute the setting. The monitor screen returns to the previous PRESET NUMBER SET table. 9. Repeat the above procedures to register positions for other preset numbers. 10. Press the MON (ESC) key to return to the previous Preset Program Menu.
1. Move the cursor to the desired preset number by moving the Joystick Controller. 2. Press the CAM (SET) key. The Preset Position Setting table shown below appears on the monitor.
CAM
: CameraTitle
POSITION NUMBER : 12 PAN/TILT/ZOOM/FOCUS SET UP POSITION
5
3. Move the camera to the preset position to be registered by moving the Joystick Controller, and adjust the zoom and focus by pressing the ZOOM TELE/WIDE and FOCUS NEAR/ FAR Control. 4. When satisfied with the position, press the CAM (SET) key. The Preset BLC (Backlight Compensation) Setting table shown below appears on the monitor.
121
|
|
|
> |
|
