A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
Text excerpt from page 14 (click to view)
Maintenance
The cabinet
Clean the outside surfaces of the appliance using a mild (non-abrasive) household cleaning product. Finish by removing remaining traces of the product with a damp cloth. Do not use cleaning products which contain alcohol (spirits), thinners and similar substances.
1
The detergent dispenser
In time, residues of detergent and fabric conditioner are likely to build up inside the detergent dispenser. It should be cleaned at regular intervals by flushing it out with water. If necessary, the whole dispenser can be taken out of the machine for cleaning. You need to pull it firmly outwards, so that it comes free of a retaining stop (Fig. 1). To remove the syphon at the inside edge of the dispenser for cleaning, you need to press it inwards and pull it upwards at the same time (Fig. 2). When you put it back, press it downwards until you hear a distinct click.
2
Opening for the detergent dispenser
Detergent residues can also build up inside the opening for the detergent dispenser. You can use an old toothbrush for cleaning this area (Fig. 3). When you have finished and put back the dispenser, run a short programme with no wash load in the machine to rinse it clean.
Cleaning inside the machine
If you mostly use your machine for low-temperature washes and/or if you use only very little detergent, you should clean the inside of the machine about once a month. This will prevent mould or stale odours from developing. Use the full recommended quantity of detergent and run a wash programme at the highest temperature with no wash load in the machine.
3
Protecting against freezing
If the washing machine is placed in an environment where the temperature sometimes falls below 0° C, there is a risk that the small amount of water which remains inside the parts of the machine will freeze and damage it. To prevent this you should: 1. Turn off the water supply and disconnect the water inlet hose from the supply tap. 2. Select a wash programme, start the machine and let the programme run for a short time. 3. Interrupt the programme by turning the programme selector to the �Reset� position. 4. Place the end of the inlet and discharge hoses down low, into the waste gully (floor drain) set into the floor. Make sure that the end of the hose does not go below the water level in the gully's (drain's) water trap. 5. Select the programme �Drain� and let that run until it is finished. 6. Turn the programme selector to the �Reset� position. The appliance is only to be used and stored indoors at normal room temperature. The manufacture is not responsible for any frost damage.
