|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good scan, great price, but almost the same with the SV260 service manual.
;
This PDF is very comprehensive. It includes drawings, parts lists, schematics, pictures, PCB drawings, mechanical layouts, etc. for all three stackable equipment. The scans are good too. Easy to read and no smudges or black lines. I have no complaints. I will make this site my first stop for finding my service manuals.
 ;
This service manual includes drawings, schematics, exploded views, parts list, operating details, and more. Very good scans, very readable. The only thing that made it a 4 star rating was on approximately 4 scans only half of the page was scanned then the other half. I would have preferred the pages to be whole scans.
;
Good manual contains all it takes to update, repair,these types of mixers.Thanks.
;
Great service. Fast response. High quality scan. Good price.
Thank you very much!!!
Oleg S.
SECTION 4 MECHANICAL ADJUSTMENTS
PRECAUTION 1. Clean the following parts with a denatured-alcohol-moistened swab: playback head pinch roller rubber belts capstan 2. Demagnetize the playback head with a head demagnetizer. (Do not bring the head demagnetizer close to the erase head.) 3. The adjustments should be performed with the rated power supply voltage (1.3 V) unless otherwise noted. Torque Measurement
Mode FWD FWD Back Tension REV Torque Meter CQ-102C Meter Reading 1.57 � 2.45 mN�m (16 � 25 g�cm) (0.23 � 0.34 oz�inch) 0.049 � 0.147 mN�m (0.5 � 1.5 g�cm) (0.007 � 0.02 oz�inch) 1.57 � 2.45 mN�m (16 � 25 g�cm) (0.23 � 0.34 oz�inch) REV Back Tension CQ-102RC 0.049 � 0.147 mN�m (0.5 � 1.5 g�cm) (0.007 � 0.02 oz�inch) more than 4.90 mN�m (more than 50 g�cm) (more than 0.7 oz�inch)
SECTION 5 ELECTRICAL ADJUSTMENTS
1. Specified voltage 2. Setting BL SKIP SOUND NORM/MB/GRV AVLS ;NR (WM-EX505 only) PRECAUTION : 1.3 V (DC) : OFF : NORM : OFF : OFF
Test tape
Type WS-48A Signal 3 kHz, 0 dB Used for Tape Speed Adjustment
Tape Speed Adjustment Procedure:
Test tape WS-48A (3 kHz, 0 dB) 16 � frequency counter
CQ-102C
CQ-102RC
set
+ �
i REMOTE jack (J301)
FF, REW
CQ-201B
1. Playback WS-48A (tape center) in the FWD state. 2. Adjust RV601 so that the frequency counter reading becomes 3,000 Hz. Specificated Value: 2,970 to 3,030 Hz 3. Check that deflection of the frequency counter reading between the beginning and the end of tape is within 1.5% (apporox. 45 Hz). Adjustment Location:
� MAIN Board (Side B) �
J301 RV601
� 12 �
|
|
|
> |
|
