Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
The only reason I gave this less than 4 stars, is because it shouldn't take 24 hrs to have the download available. I was surprised to find that I had to wait until the next day to be able to download the manual that I paid for.
The manual itself is the correct manual.
Text excerpt from page 14 (click to view)
WM-FS473
5-5. SCHEMATIC DIAGRAM (DISPLAY SECTION)
r
WAVEFORM
1
SUB
1.1Vp-p
75kHz 13.6µsec
IC701 %�
VOLT/DIV : 0.2V AC TIME/DIV : 5 µsec
r
IC BLOCK DIAGRAM
OUT GND VCC
IC702 PST9018NL
5
4
+
OP1 CO1
�
+ �
1
NC
2
3
Note: � All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1/4 W or less unless otherwise � � � � � specified. C : panel designation. U : B+ Line. Power voltage is dc 3 V and fed with regulated dc power supply from battery terminal. Voltages and waveforms are dc with respect to ground under no-signal (detuned) conditions. Voltages and waveforms are dc with respect to ground in playback mode. no mark : FM (RADIO SECTION) PLAY (TAPE SECTION) ( ) : AM Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. Waveforms are taken with a oscilloscope. Voltage variations may be noted due to normal production tolerances. Circled numbers refer to waveforms.
