|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Once again owner-manual.com has saved the day for me, and come through with the manual I need. I looked other places too, and couldn't find it anywhere. Thank You owner-manual.com!!! You're the BEST!
 ;
very good quality that can be magnified several times, and it remains readable.
For sure I will return next time the need for a service manual arise.
 ;
The service manual is really great - thanks to it I was able to install the laser unit and thus "save" my CD-player, which seemed to be impossible before I had the manual.
 ;
Downloaded the Service manual OK of the Technics Piano and have now repaired it and its going fine. Excellant; thank you for the fine servce. A.M
 ;
This site is working fine! Did buy a manual for SX-EX25L and after a while I could download it and fix the problem. Nice and easy!
TUNER SECTION
0 dB=1 µV
FM VCO Adjustment Procedure :
FM RF signal generator 0.01µF
[AM] RADIO ON/BAND button : AM
AM RF signal generator
Put the lead-wire antenna close to the set.
to ANT (TP1) Carrier frequency : 98MHz Modulation : No moduration Output level : 0.1V (100dB)
30% amplitude modulation by 400Hz signal. Output level : as low as possible
1. 2. 3.
Connect the frequency counter to the positions shown below. Turn the set to 98 MHz. Adjust RV1 for 19,000 Hz reading on the frequency counter.
[FM] RADIO ON/BAND button : FM
FM RF signal generator 0.01µF to ANT (TP1)
Specification Value: Digital frequency counter 18,900 to 19,100 Hz
Frequency counter TP23 1µF
+ �
22.5kHz frequency deviation by 400Hz signal. Output level : as low as possible Level meter 16� set
+ � 2 REMOTE jack (J701)
(IC7 pin !�) 100� IC7 pin 9
Adjustment Location : [TUNER BOARD] � SIDE A �
� Repeat the procedures in each adjustment several times, and the frequency coverage and tracking adjustments should be finally done by the trimmer capacitors. AM TRACKING ADJUSTMENT Adjust for a maximum reading on level meter. L4 621kHz CT1 1,395kHz FM IF ADJUSTMENT Adjust for a maximum reading on level meter. L3 10.7MHz FM VOLTAGE ADJUSTMENT 1.05 to 1.15 V L2 76MHz
L2 : FM Voltage Adjustment L3 : FM IF Adjustment
TP1
CT1 : AM Tracking Adjustment
TP13 IC7 L4 : AM Tracking Adjustment
RV1 : FM VCO Adjustment
�8�
|
|
 |
> |
|