|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
WM-FX888 SECTION 4 MECHANICAL ADJUSTMENTS
PRECAUTION 1. Clean the following parts with a denatured-alcohol-moistened swab: playback head pinch roller rubber belts capstan 2. Demagnetize the playback head with a head demagnetizer. (Do not bring the head demagnetizer close to the erase head.) 3. Do not use a magnetized screwdriver for the adjustments. 4. The adjustments should be performed with the rated power supply voltage (1.3 V) unless otherwise noted. Torque Measurement
Mode FWD CQ-102C FWD Back Tension Torque Meter Meter Reading (1.47 � 2.94 mN�m) 15 � 25 g�cm (0.22 � 0.36 oz�inch) (0.029 � 0.196 mN�m) 0.3 � 2.0 g�cm (0.004 � 0.01 oz�inch) (1.47 � 2.94 mN�m) 15 � 25 g�cm (0.22 � 0.36 oz�inch) (0.029 � 0.196 mN�m) 0.3 � 2.0 g�cm (0.004 � 0.01 oz�inch) (more than 3.43 mN�m) more than 35 g�cm (more than 0.5 oz�inch) Type WS-48A Signal 3 kHz, 0 dB Used for Tape Speed Adjustment
SECTION 5 ELECTRICAL ADJUSTMENTS
PRECAUTION 1. Specified voltage : 1.3 V (DC) 2. Setting SOUND RV/MB/GRV : OFF AVLS : OFF ;NR : OFF BL SKIP : OFF
TAPE DECK SECTION
Test tape
0 dB=0.775 V
Tape Speed Adjustment Setting: Function: TAPE
Test tape WS-48A (3 kHz, 0 dB) 16 � frequency counter
REV CQ-102RC REV Back Tension FF, REW CQ-201B
set
+ �
i jack (J701)
Procedure: 1. Playback WS-48A (tape center) in the FWD state. 2. Adjsut RV601 so that the frequency counter reading becomes 3,000 Hz. Specification Values: 2,970 to 3,030 Hz 3. Playback WS-48A (tape center) in the REV state. Check that the frequency counter reading is within 2% (approx.60 Hz) of the reading of step 1. Adjustment Location: MAIN BOARD (See page 12)
11
|
|
|
> |
|
