|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It's complete and helpful manual with good quality of scan. Thanks very much.
;
The service was quick and simple, finding the service manual easy and it appears to be the original with colour schematics. It contained the info I was after and so sorted the problem.
I have copied it to CD and attached the envelope to the inside back cover of the owners manual. Good manual and excelent service. Robin Wood, Wood Electronics, New Zealand.
;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
MODELS: WS-48313 / WS-48413 / WS-55313 / WS-55413 / WS-65313 / WS-65413
SERVICING THE DIAMONDSHIELD� 1. DiamondShield� Removal Procedure
The location of the DiamondShieldTM molding clips may vary between models, top and bottom, or sides. Use
the appropriate disassembly procedure given below. Note: Wear gloves when handling the DiamondShield� to prevent finger prints.
Top & Bottom Molding Clips
Side Molding Clips
1. Gently insert a small screwdriver between the DiamondShield� and one end of the clip to pry the clip loose.
1. Gently insert a small screwdriver between the DiamondShield� and one end of the clip to pry the clip loose.
2. Remove both clips by pulling them toward you.
2. Remove both clips by pulling them toward you.
3. Carefully insert a small screwdriver into the gap at the top/center point of the Shield and pull the Shield slightly away from the unit. Place your hands at the points shown and gently bow the Shield toward you and remove from the unit. Then re-install the two clips.
3. Carefully insert a small screwdriver into the gap at the side/center point of the Shield and pull the Shield slightly away from the unit. Place your hands at the points shown and gently bow the Shield toward you and remove from the unit. Then re-install the two clips.
2. DiamondShield� Installation Procedure
*(See the Parts List for DiamondShield� part numbers) To install the DiamondShieldTM, reverse the above Removal Procedure.
Page 15
|
|
|
> |
|
