|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
PHILIPS PE1642 Owner's Manual
Hi,
you have complet fullfilled my expectance.
Price is OK.
Robert Schmid
 ;
Came in the mail within a few hours. Gave clear instruktion on maintaines. Is of great use to have this manual in house
;
Easy to access. Clear instructions. No problems. Printed fine.
;
Great scan but please note that it is entirely in GERMAN.
;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
6. The text line LOADING blinks on the right while downloading. The bar graph changing from s to P displays the downloading progress. 7. END appears on the right after downloading has been completed. The progress bar disappears. 8. Editing the DATA TITLE. For further information, refer to Data Title on the next page. Notes: � Preset data for up to 8 cameras can be downloaded. � Downloading time is approximately 2 minutes per camera. � Any previously preset data is overwritten by the downloaded data. � Press the HOME/ESC button while downloading to terminate downloading. ERROR 3 appears. The progress bar disappears. � END and error messages remain on the menu until the next operation is performed. � Check that the right unit address is selected for the combination camera when the RS-485 mode is used. If the numbers do not agree, the camera cannot be operated. Therefore, preset data cannot be downloaded. � Error Display The following messages appear on the monitor when an error occurs during downloading. Message ERROR 2 Cause Lack of memory Note Memory capacity was exceeded while downloading. ERROR 3 Causes except above Downloading not possible for some reason other than the above.
Uploading
1. Display the PRESET DATA LOAD menu. 2. Select a camera number between CAM1 and CAM8 by moving the joystick up or down. 3. Press the PRESET/SET/PROGRAM PRESET button. The camera number and upload menu appear on the monitor as shown below.
CAM1: DOWN LOAD UP LOAD DATA TITLE
4. Select UP LOAD by moving the joystick up or down. 5. Press the PRESET/SET/PROGRAM PRESET button. Uploading starts.
CAM1: DOWN LOAD UP LOAD DATA TITLE END LOADING Blinking
6. The text line LOADING appears on the right while uploading. The bar graph changing from s to P displays the uploading progress. 7. END appears on the right after the uploading has been completed. The progress bar disappears. Notes: � Preset data for up to 8 cameras can be uploaded. � The uploading time is approximately 2 minutes per camera. When uploading is completed, combination cameras such as the WV-CS854 will move during the initial periods to fit the new settings. � The camera picture may change as a result of uploaded data. Access the Camera Setup menu to make any necessary settings. � Any previous preset data is overwritten by the uploaded data. � Press the HOME/ESC button to terminate uploading. ERROR 3 appears and the progress bar disappears. � END and error messages remain on the menu until the next operation is performed.
23
|
|
|
> |
|
