|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
UNIT SELECTION
To control the system, you need to select a desired unit (system unit, recorder, monitor, or camera) at the beginning.
I Recorder Selection
Notes: � In advance, you need to set HDD-unit maps. (Refer to p. 78 Associating Recorder Numbers with Unit Numbers.) � In the factory default, Recorder 1 to 16 is associated with Unit 1 to 16. 1. Enter a recorder number by pressing numeric buttons. The entered number will appear on the LCD.
I System Unit Selection
Notes: � In advance, you need to set the unit number for each system unit. (Refer to the operating instructions of system units.) � 1 to 99 are available for the unit number. 1. Enter a unit number by pressing the numeric buttons. The entered number will appear on the LCD.
Mon02 Cam128 F1 F2 F3
____2 F4
Mon01 Cam016 F1 F2 F3
___16 F4
2. Press the RECORDER/UNIT button. The system will become ready for control, and the monitor number, camera number, and system unit number will appear on the LCD.
2. Press the RECORDER/UNIT button while holding down the SHIFT button. The system will become ready for control. Then, the monitor number, camera number, and system unit number will appear on the LCD.
Mon02 Cam016 Unit16 F1 F2 F3 F4
Notes: � Three seconds after, model number will appear in place of unit number.
Mon02 Cam016 F1 F2 F3
Unit16 F4
Note: Three seconds after, model number will appear in place of unit number. To display the unit number again, hold down the RECORDER/UNIT.
Mon02 Cam016 F1 F2 F3
HD316 F4
Mon02 Cam016 F1 F2 F3
HD316 F4
� If you have entered a wrong recorder number, �Invalid� will appear on the LCD. Then, the LCD will return to the status before the recording selection.
� If you have entered a wrong unit number, �Invalid� will appear on the LCD. Then, the LCD will return to the status before the system unit selection.
Invalid
Invalid
41
|
|
|
> |
|
