|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Window opening measurements
Excessive Weight Hazard Use two or more people to move and install air conditioner. Failure to do so can result in back or other injury.
Important: Observe all governing codes
T
16� r
Checkthe location where air conditioner will be installed. Proper installation is your responsibility,Mcake you haveeverything sure necessary correct installation. for The location should provide: Grounded electrical outlet within four feet of the window. Do not usean extensioncord. Free movement of air to rooms to be cooled.
l l
and ordinances.
I
I
A large enough opening for the air conditioner. Installation parts are supplied for double-hungwindowsup to 38� wide. Adequate wall support for weight of air conditioner. Air conditioner weighsbetween 55 and 65 pounds. Do Not install the air conditioner in an area where the front panel will be exposedto heat sourcesthat will raise the panel surface temperature above120°F.
l
l
|
|
|
> |
|
