WHIRLPOOL X05002X00
Owner's Manual

Operating Your Air Conditioner
To obtain the best possible results from your air conditioner, it is important that you operate it properly. This section tells you how to set the controls and how to direct the cooled air.

Starting

your

air conditioner

Fire Hazard Do not use an extension cord. Doing so can result in death, fire, or electrical shock.

Electrical Shock Hazard Plug into a grounded 3-prong outlet. Do not remove ground prong. Failure to follow these instructions can result in death or electrical shock.

1. Set the System Control to the
desired setting. LO COOL - for sleeping comfort Hi COOL - for maximum cooling FAN ONLY -to circulate room air without cooling it 2. Turn the Thermostat Control to number 6 (mid setting). You can adjust the air conditioner�s cooling performance by setting the Thermostat Control to a higher number for more cooling or to a lower number for less cooling. Experiment to find the setting(s) that suits you best.

IMPORTANT: If you turn the air conditioner off, or if the compressor turns off when you lower the Thermostat Control, wait at least three minutes before turning the air conditioner back on. If you don�t wait, you may blow a fuse or trip a circuit breaker.

5