|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
;
Great deal, you are the only one on earth who could deliver this old manual. Thx so much and have nice chrismas
 ;
Everything is OK. Owner's Manual I downloaded ( I get link for it by email).
;
The only reason I gave this less than 4 stars, is because it shouldn't take 24 hrs to have the download available. I was surprised to find that I had to wait until the next day to be able to download the manual that I paid for.
The manual itself is the correct manual.
Model X-12 Owner's Manual
6
When the leader part is forwarded, press the [RESET] button to set the counter to "000." Select the track to be recorded with the [REC TRACK] selector.
Select track 1 (the indicator will change to red) or whatever track you prefer to record on.
This will change to red light and track 1 can be recorded.
1
10
Put X-12 in the record standby mode.
First, press the [PAUSE] button, then the [RECORD] button. The [PLAY] button will be engaged automatically at the same time. The tape will remain paused in the record mode.
7
11
When the [LINE OUT/PHONES] knob is slowly advanced, the input monitor sound will be heard in the headphone.
While monitoring the sound in the headphone, watch the level meter and adjust the recording to a suitable level. Because the recording level cannot be adjusted with a fader, optimum recording levels must be determined by the sound volume applied to the mic or by adjusting the distance to the mic.
<NOTE>
Do not move the [REC TRACK] selector during recording. If this is moved accidentally during recording, the recording track will switch.
<CAUTION>
If you must monitor for a long time, be careful not to raise the [LINE OUT/PHONES] knob too high. If you monitor for long hours at high volumes, it could impair your hearing.
8 9
Try speaking into the mic.
The level meter LED will blink.
For optimum gain, adjust the [LINE-MIC] knob CW (toward "MIC").
Adjust the [LINE-MIC] knob such that the level meter "+3" LED is illuminated at maximum sound volume. When recording line level sound sources such as a keyboard and electric guitar, the optimum gain is obtained by rotating the [LINE-MIC] knob CCW (toward "LINE").
METER +6 +6
If this LED blinks frequently, it indicates that input level is too high.
12
After confirming the level, release the [PAUSE] button (The [PAUSE] button is pressed again) to start recording. If recording is to be momentarily stopped, press the [PAUSE] button. If recording is to be ended, press the [STOP] button.
Following the procedures up to this point, the sound applied to the microphone has been recorded on track 1 as shown in schematic below. Now, let's try recording another sound source to another track with the same procedures. Also, lets playback the recorded sound on each track as described below.
13
+3
+3
0
0
Set the gain so that LED's within this range remain lit.
-5
-5
-10
-10
Track 4 Track 3 Track 2 Track 1 Microphone
<NOTE>
Be careful not to continue recording, if the level meter "+6" LED lights up frequently, as this will indicate the sound can be distorted.
10
|
|
|
> |
|
