|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Zeer duidelijke afdrukken op A4-formaat , zeer uitgebreide handleiding . Pluspunt ,zeer snelle
respons van jullie , binnen de 24h . Top !!!
;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
;
I was impressed with the quality of service (frequent e-mails to let you know the status of your order), and the speed at which the download became available. The manual was a life saver and was not easy to track down. Thank you for such an excellent service.
;
the manual was just what i wanted it had all the revelent information required to operate the hifi .Iwould use any manual i downloaded for any item which needs a manual
;
Die gewünschte Bedienungsanleitung wurde vereinbarungsgemäß in deutsch bereitgestellt. Sie ist gut lesbar. Kein Kauderwelsch.
Danke für den Service.
To begin calibration of the VCTCXO, select �Non-Signaling Test� from the �Modes� pull-down menu in PhoneTool and complete the following steps:
1. 2. 3. 4.
Click the "Non-Signaling Mode" button. Click the �Check Connection� button. Select TSC = 5. (Make sure the call box has the same setting for TSC) Check the �1900 Band� box to the right of the TX ARFCN box. (Very important! Not checking this box will cause the phone to transmit in the DCS band instead of the required PCS band). 5. Type �810� in the TX ARFCN box and press ENTER (on the keyboard). 6. Type �15� in the �TimeSlot 1� box and press ENTER (on the keyboard). 7. Click the �Burst Tx� of the RF Mode. This enables the transmitter. Check that a Tx signal is seen on the GSM Test Set. Measure the frequency error. A calibrated VCTCXO should provide a frequency error within ±500Hz at room temperature. 8. The frequency (and therefore the VCTCXO) is adjusted by changing the AFC DAC value in PhoneTool. Adjust the AFC DAC value until the frequency error measured on the GSM Test Set is within ±500Hz. Note the DAC value required. 9. Click �General Off� to turn off the transmitter. 10. From the �Modes� pull-down menu, select �EEPROM.� 11. Click �Read Values From Phone�
PROVISIONAL ISSUE
� 9-16 �
|
|
|
> |
|
