|
|
|
Who's Online
There currently are 5897 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
X92-4400-0x/4730-0x X92-4740-0x/4750-0x DISASSEMBLY AND ASSEMBLY OF MECHANISM
â� Disassembly for loading cam (30) drive arm (19), lock slider (23), and rear lock arm (24)
1) The screw (D) and the loading cam (30) are removed. Note: The screw for loading cam (D) is not reusable. Please be sure to exchange. 2) The spring (58) for trigger sliders is removed. 3) The stopper (49) is removed. 4) The spring (64) of the rear lock arm (24) is removed. 5) The screw (B) and washer (K) of the drive arm (19) are removed, and the drive arm (19) is moved back to rear side. The drive arm (19) is removed. 6) Lock arm (25 and 26), lock slider (23), rear lock arm (24) and each gear is removed.
LOADING CAM (30) 35 16 15 32 33 34 26 25 B 49 24 64 BK 19 23 65
58
D 1
â� Assembly for the loading cam (30) drive arm (19), lock slider (23), and rear lock arm (24)
1) The trigger slider (15) is fixed in the main chassis (1), and is moved back to rear side. 2) The loading slider (16) is fixed to the trigger slider (15). Note: At this time, it is cautious of the position of the hook of the loading slider (16). 3) The gear (4 pcs) is fixed in main chassis (1). 4) The lock arm (25 and 26) and the rear lock arm (24) are fixed. 5) The spring (65) is covered over the lock slider (23). The spring (65) is assembled with through for a main chassis (1) hole. It takes care that the spring (65) does not run aground to the lock slider (23). 6) The loading slider (16) is moved back to the rear side. The lock arm (25 and 26) moving to OPEN position, and the drive arm (19) is fixed (Put in seven places boss).
23 16 65
7) The loading slider (16) is fixed on the washer (K) and the screw (B). (Torque 3±10% kgf.cm) 8) The lock arm (25 and 26) is closed by hand and the lock slider (23) is moved for close position, and the stopper (49) is fixed on the screw (B). (Torque 3±10% kgf.cm) 9) The loading cam (30) is fixed on the screw (D). (Torque 1.5±10% kgf.cm) 10) The spring (58) is fixed to the trigger slider (15) and the loading slider (16). 11) The spring (64) is fixed to the rear lock arm (24).
64
B K 19
24
15 58 1 D
30
17
|
|
|
> |
|
