|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
XC-LA21
The following work is done before Drawer is put on Chassis. (1) It is confirmed that Carriage 300 is clamped, and Clamper has fallen. (2) It is confirmed to Drawer to be built in neatly in order of Carriage 200 and 100. (3) Arm Stopper B is moved horizontally (inside) as shown in the figure below. A (4) Pulls Slider 2 until the lock comes off to the direction of ta front side. B Note : Do not lift Arm Stopper B for above when you move Arm Stopper B. There is a possibility to bend the spring when Arm Stopper B is lifted, and the spring bends. And, when Arm Stopper B becomes floatage feeling, Drawer is caught. Coming off in the spring is noted.
7 Assembly of Drawer and Chassis
5 Its right side is slowly lowered up to the angle by which Bevel
Gear can do in the slide while doing Drawer back and forth by about 5mm.
4
3 5
2 Lac teeth
Bevel Gear
Arm Stopper B
Gear Idler A (black)
A
Slider 2 The lock comes off.
6 When peeps from the inside of Drawer when the receiving part
of Gear is fixed into the concave part of Bevel Gear, the place where it is fixed is comprehensible. Coming off of a black gear is noted. Direction of front
B
Drawer
1 This
part of Drawer is put on Chassis like the arrow. 10mm is opened.
6
Drawer
1
Concave of Bevel Gear Receiving part of Gear
Chassis
7 8 2 The lac teeth and Gear Idler A are matched, and it is pressed
under the diagonal lightly.
3 Right this side of Drawer is lifted. 4 Drawer is moved back and forth, and stops Drawer with the
point which it enters left.
Chassis hook
48
|
|
|
> |
|
