|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
RADIO OPERATION
Tuning
ON/STANDBY button to turn the power on. 2 Press the TUNER (BAND) button. 3 Press the TUNER (BAND) button to select the desired frequency band. (FM ST, FM or AM) 4 Press the TUNING/TIME (%UP or �DOWN) button to tune into the desired station.
1 Press the
1 2,3, 5,6
Manual tuning : 4
Press the TUNING/TIME (%UP or �DOWN) button as many times as required to adjust the frequency shown on the display to the frequency of the desired station.
Auto tuning :
When the TUNING/TIME (%UP or �DOWN) button is pressed for more than 0.5 second, scanning will start automatically and the tuner will stop at the first receivable broadcast station.
4 1
2,3, 5,6
Notes : � When radio interference occurs during auto scan
tuning, auto scan tuning may stop automatically at that point. � If a weak station signal is found during auto scan tuning, the station will be skipped. � To stop the auto tuning, press the TUNING/TIME (%UP or �DOWN) button again. � When a RDS (Radio Data System) station is tuned in, the frequency will be displayed first, and then the RDS indicator will light up. Finally, the station name will appear. 5 To receive an FM stereo transmission, press the TUNER (BAND) button so that the �ST. indica� tor on the display lights up. � � � will light up when an FM broadcast is in stereo. 6 If the FM reception is weak, press the TUNER (BAND) button so that the �ST. indicator goes � off. The reception changes to mono, the sound becomes clearer.
After use :
Press the ON/STANDBY button to enter the standby mode
Note : � The last station turned in will be recalled, even
after changing the tuning band or the function, or after switching the unit to the standby mode.
�
19 EN
|
|
|
> |
|
