|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
BACK
FRONT
B
2.5mm A/F ALLEN KEY
Use the 2.5mm A/F Allen Key and looking from the left hand side, adjust the back (3rd) screw to tilt the platter assembly FRONT to BACK as shown above. DO NOT over tighten or slacken the fixing screw too much. Adjustment of this screw will NOT change the LEFT to RIGHT level. Belt riding position
1 mm gap between the Belt and the Pulley flange Ref.: Pulley flange thickness is 1mm
NOTE: �
The Belt should ride with at lease 2mm clearance from the bottom of the Inner Platter
With the belt riding higher on the pulley (i.e. more than 1mm gap), the rotational speed would be slightly increased.
Drive Belt Set-up and Maintenance
1 If the levels are adjusted but the drive belt rides a little too high, then remove the belt and gently stretch it. Wait a couple of minutes and refit the drive belt and the outer platter and check the running position again (Repeat this process if necessary)
�
With the belt riding lower on the pulley (i.e. less than 1mm gap), the rotational speed would be slightly decreased.
Roksan Audio ltd
All specifications are liable to change without notice. E&OE
Xerxes.20 Record Player User Manual
General Use Version 3.0
Page 14 of 22
ENGLISH
|
|
|
> |
|
