|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
XL-520H,520E/CP-520,520E
� LCD indication error.
Is +5V applied to the pin 8 (VDD) of IC701? No Is +5.6V applied to the emitter of Q704? Yes Yes Check the pattern between Q704 and IC704. Check the pattern between Q704 and CNS603.
No
Is +5V applied to the pin 38 (SYS STOP) of IC701? No Yes
Check the PWB pattern between the collector of Q702 and Q701.
Check the peripheral parts of IC701 and LCD701.
� Laser lighting failure.
Is +2.5V applied to the pin 42 of IC802? Does the laser come on when pattern cut between pin 21 of IC801 and pin 42 of IC802. Yes Yes No Check the PWB pattern between IC701 and IC802 (BUCK/CCE/ BUS0~3) Is approx. 2V applied to the collector of Q801. No Yes Check CNW802. If it is normal, the optical pickup is faulty. Check the peripheral parts of IC801 and Q801. If it is normal, the optical pickup is faulty.
No
� Focus failure.
Does the optical pickup move up and down when the disc is removed? Yes Is the following waveform ouput at the pin 11 (FEI) of IC801 when the disc is set?
Pin11 (FEI)
No
Check as stated in item "FOCUS SERVO SAWTOOTH WAVE FAILURE".
Check the periphery of IC801 and CNW802. is it normal? No Yes The optical pickup is faulty. Yes The periphery of IC801 or CNW802 is faulty.
Pin16 (FSO)
Yes
Pin6 (SBAD)
Is the waveform shown above input at the pin 50 (SBAD) of IC802? Yes IC801 is faulty.
Check the pattern between pin 6 of IC801 and pin 50 of IC802. No
� 32 �
|
|
|
> |
|
