SHARP XL-530H
Owner's Manual

CASSETTE OPERATION

s Cassette tape
q For playback, use normal or low-noise tape for the best sound. (Metal or CrO2 tape is not recommended.) For recording, use only normal tape. q Do not use C-120 tapes, tapes with large diameter reels, or poor-quality tapes, as they may cause malfunctions. q Before loading a tape into the cassette compartment, tighten the slack with a pen or pencil. q Cassettes have removable tabs which prevent accidental recording or erasing from taking place. Removing the tab will protect the corresponding side from being erased. Cover the tab holes with adhesive tape to erase or record again.

Side A (1)

Tab for side B (2)

Tab for side A (1)

s Tape playback

1 2

Press the ON/STAND-BY button to turn the power on. Press the FUNCTION button until "TP" appears in the display. Open the cassette door by pushing the area marked "7 PUSH EJECT". Load the cassette into the cassette compartment. Press the

1 2

5

q Press the TAPE button on the remote control.

3 4 5

0 button.

To stop playback:

4 3

Press the s button. Fast forward/rewind: To advance the tape, press the s button, then press the button. To rewind, press the s button, then press the button.

2

3

5 1 2

Caution: q When removing the cassette tape, press the s button, and then open the cassette compartment. q Before changing from one tape operation to another, press the s button. q If a power failure occurs during tape operation, the tape head will remain engaged with the tape and the cassette door will not open. In this case, wait until power is restored. q Even if the button is pressed during tape playback, the unit will not enter the pause mode.

0

10