This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 15 (click to view)
Setting the clock
/
XL-MP110E
5
Press the or button to adjust the hour and then press the MEMORY/SET(MEMORY) button.
Press the or button once to advance the time by 1 hour. Hold it down to advance continuously.
/
6
Press the or button to adjust the minutes and then press the MEMORY/SET(MEMORY) button.
In this example, the clock is set for the 24-hour (0:00) display.
Press the or button once to advance the time by 1 minute. Hold it down to change the time in 5-minute intervals. To con�rm the time display: [When the unit is in the stand-by mode] Press the CLOCK/TIMER button. The time display will appear for about 10 seconds. [When the power is on] Press the CLOCK/TIMER button. Within 10 seconds, press the or button to display the time. The time display will appear for about 10 seconds. Note: The "CLOCK" will appear or time will �ash to con�rm the time display when the AC power supply is restored after a power failure or unplugging the unit. If incorrect, readjust the clock as follows. To readjust the clock: Perform "Setting the clock" from step 1. If the "CLOCK" does not appear in step 3, step 4 (for selecting the 24-hour or 12-hour display) will be skipped. To change the 24-hour or 12-hour display: 1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 36 for details.] 2 Perform "Setting the clock" from step 1. Note: The clock can also be set with the remote control.
1 2 3
Press the ON/STAND-BY button to turn the power on. Press the CLOCK/TIMER button. Within 10 seconds, press the or button to select "CLOCK", and press the MEMORY/SET(MEMORY) button.
4
Press the or button to select 24-hour or 12hour display and then press the MEMORY/SET(MEMORY) button.
"0:00" "AM 12:00" "AM 0:00"
The 24-hour display will appear. (0:00 - 23:59) The 12-hour display will appear. (AM 12:00 - PM 11:59) The 12-hour display will appear. (AM 0:00 - PM 11:59)