|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Operating the XM610
USING THE DIGITAL EFFECTS
The XM610 features a built-in, high quality, 24 BIT Digital Signal Processor offering studio grade effects. The DSP features clean Delay, lush Reverbs and multi-effects like Chorus + Delay or Chorus + Reverb. You can add a broad range of studio quality effects by simply dialing through the 100 presets. The following details the operation of the internal DSP effects: 1. Connect a mic or instrument to the desired channel, and adjust the volume and equalizer to your liking. 2. Now select the desired preset using the EFFECTS SELECT switch. Set the DSP SELECT switch to one of the following 100 effects: 0-9 10 - 19 20 - 29 30 - 39 40 - 49 50 - 59 60 - 69 70 - 79 80 - 89 90 - 99 Performance Hall Reverb Plate Reverb Spring Reverb Echo Flange + Verb Chorus + Verb Echo + Verb Chorus Flange
4. Once you have selected the desired effect preset, raise the EFX control on the channels you wish to apply the digital effect to. 5. Now use the EFX RTN knob in the MAIN/MONITOR section to adjust the EFFECTS Return level. The EFX control is the overall level control for the DSP effects processor. If you are not using the XM610 in MAIN/ MONITOR or BRIDGE mode, be sure to raise the EFX RTN control up on both the MAIN and MAIN/ MONITOR sections so the level of effect is the same in both speakers. NOTE: If the effect sound is distorted even though the EFX RTN is turned all the way down, lower the EFX controls of each channel.
SENDING AN INDEPENDENT MIX TO THE MONITOR SPEAKERS
The XM610 allows you to operate the power amplifiers in a MAIN/ MONITOR mode. This lets you use one amplifier for speakers facing the audience, and the other amplifier for the monitor speaker facing the musicians.
1. Set the channel MONITOR section and VOLUME control to the "0" position. 2. Raise the MONITOR controls for the channels that you wish to hear from the monitor speakers. NOTE: The MONITOR controls are not affected by the level settings of each channel. This allows you to create a mix for the monitors that is independent of the MAIN mix. 3. Use the graphic equalizer and MASTER controls of the MAIN/MONITOR sections to adjust the overall volume and tone. 14
|
|
|
> |
|
