|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
 ;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
;
Great copy of the manual, has all information required for servicing,
;
I work at an authorized service center and I can tell if a manual is as it should be. This one is. It may be a scan, but a very good one at that. The interesting part for me was the curcuit diagram which was scanned at high quality, making it as good as the original. I will definitely be back as a customer. I need not say this, but I will: the price was the best. Thank you owner-manuals.com .
;
really a very good manual even sometimes the quality is no so good as before still very readible and very very useful!
XM-PX33BU/XM-PX33WT
<Removal of the MD mechanism>
Removing the spindle motor (See Fig.9)
1. Unsolder the part e of the flexible wire extending from the underside of the chassis assembly to the spindle motor. At this time, do not spill flux on the gear and others. 2. Remove the three screws G attaching the spindle motor and detach it from the chassis assembly.
Slit washer Worm gear
H
Shaft holder e
G
chassis assembly
Spindle motor f g Pickup unit
Removing the pickup unit (See Fig.9)
1. Remove the slit washer and the worm gear from the underside of the chassis assembly. 2. Remove the screw H then detach the shaft. attaching the shaft holder,
Lead screw
Fig.9
3. Pull out the part f and g in the directions of the arrows to remove the pickup unit and the lead screw.
Lead screw
I
Lead spring
Removing the pickup (See Fig.10 and 11)
1. Remove the screw I attaching the lead spring, then detach the lead spring. 2. Pull out the shaft from the pickup. ATTENTION: When handling the pickup unit, touch the parts marked in Fig.11 only. Fig.10
Pickup
Touch the parts only.
Fig.11
1-7
|
|
|
> |
|
