|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
XM-PX33BU/XM-PX33WT
<Removal of the MD mechanism>
Removing the spindle motor (See Fig.9)
1. Unsolder the part e of the flexible wire extending from the underside of the chassis assembly to the spindle motor. At this time, do not spill flux on the gear and others. 2. Remove the three screws G attaching the spindle motor and detach it from the chassis assembly.
Slit washer Worm gear
H
Shaft holder e
G
chassis assembly
Spindle motor f g Pickup unit
Removing the pickup unit (See Fig.9)
1. Remove the slit washer and the worm gear from the underside of the chassis assembly. 2. Remove the screw H then detach the shaft. attaching the shaft holder,
Lead screw
Fig.9
3. Pull out the part f and g in the directions of the arrows to remove the pickup unit and the lead screw.
Lead screw
I
Lead spring
Removing the pickup (See Fig.10 and 11)
1. Remove the screw I attaching the lead spring, then detach the lead spring. 2. Pull out the shaft from the pickup. ATTENTION: When handling the pickup unit, touch the parts marked in Fig.11 only. Fig.10
Pickup
Touch the parts only.
Fig.11
1-7
|
|
|
> |
|
