|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Impressively thorough. Even the simple operators manual helped me "fix" one of the 2 CD players in the unit. This unit reads CD's from the top so they should be installed in the magazines "upside down" from typical CD players. The CD player service manual helped me unjam a stuck carriage because somebody transported the box laying down loaded with CD's. A little lens cleaning & the player now works well! Thanks for you help at a great price! Joe
;
I was skeptical at first but later found the manual to be good quality for the price. It took a couple hours to receive the email with the download link, well worth the wait. Thanks.
;
very helpful, I could not have cleaned motherboard and replaced the main fan without it
 ;
Good manual, schematics nice and clear with good quality scanning. Woul dhave been nice to have immediate access after purchasing though.
;
I was very glad recieving the service manal from You. Manuals were delivered promptly and were correct as advertised. A complete and very usefull service manual with all details. Thank you!
XM-PX3BU/XM-PX3TG
Maintenance of MD pickup
1. Cleaning of pickup lens
(1) Prior to changing the pickup, clean the pickup lens. (2) For cleaning the lens, use the following cotton swab after mearsing it in alcohol. Product No. JCB-B4; Manufacturer;Nippon Cotton Swab
Procedures of changing the MD pickup
Change the MD pickup by referring to "Removing the MD pickup" in the Disassembly method.
2. Confirmation of the service life of laser diode when the service life of the laser diode has been exhausted, the following symptoms will appear.
(1) The RF output (EFM output and eye pattern amplitude) will become lower. (2) The drive current required for light emitting of laser diode will be increased.
Set the pickup to [TEST] mode according to the procedures described in the Adjustment method.
Adjust the laser power 560 W.
Power supply voltage 1.5V
20mV Adjustment
Adjust the disc. Confirm the service life according to the following flow chart: Completion of changing the MD pickup.
Can the laser power adjust under test mode?
NO
Change the pickup
YES
Is the drive current of laser diode 55mA or less?
NO
Change the pickup
Be sure to perform not only adjustment and operation of this system so carefully as not to directly look at the laser beam or touch on the body.
YES
OK.
3. Method of measuring the drive current of laser diode
When the voltage measured at the both side of carbon resistor R301 on the MD servo P.C. board (LVB20008) have become 12.1mV or over, the service life of the laser diode is judged to have been exhausted.
4. About Semi-solid state resistor of pick up
This is adjusted in the maker of pick up . Be careful please not to touch pick up .
2-6
|
|
|
> |
|
