|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
 ;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
;
Nice pdf file of the manual sent promptly. Thanks.
;
Complete MFG Service Manual at a good price FAST !
XM-PX50WT
<Removal of the MD mechanism section>
Prior to performing the following procedures, remove the MD door assembly, the holder assembly, the chassis assembly and the main board.
Slit washer Worm gear
Shaft holder Soldering g
J
I
Removing the spindle motor (See Fig.11)
1. Unsolder the part g on the flexible wire extending from the underside of the Chassis assembly to the spindle motor. ATTENTION: Do not spill flux on the gear and others. 2. Remove the three screws I motor. attaching the spindle
Chassis assembly Part i Part h Pickup unit
Spindle motor
Fig.11
Removing the pickup unit (See Fig.11)
ATTENTION: When handling the Pickup unit, touch the parts marked in Fig.13 only. 1. Remove the slit washer and the worm gear from the underside of the Chassis assembly. 2. Remove the screw J attaching the shaft holder and draw out the shaft (lead screw). 3. Pull out the Pickup unit and the lead screw while disengaging the part h and i.
Lead screw
K
Lead spring
Pickup
Fig.12
Removing the pickup (See Fig.12 and 13)
Touch these parts only.
ATTENTION: When handling the pickup unit, touch the parts marked in Fig.13 only. 1. Remove the screw K and the lead spring. 2. Pull out the shaft from the pickup.
Fig.13 1-8
|
|
|
> |
|
