PIONEER X-NM50MD/DBXCN
Owner's Manual

Using the timer
7 Choose the recorder(s) you want to use. Use the 5 and � buttons to select either MD, TAPE or both MD and TAPE, then press ENTER.

12
Activating/deactivating the timers
You might choose to cancel the wake up timer, but keep the settings for a later time. You can also set the record timer and still keep your wake up timer settings. 1 Switch the system to standby. 2 Press TIMER repeatedly to cycle through the timer options. Choose TIMER OFF to deactivate all timer settings. To reset the wake up timer, or the record timer (or both), select the corresponding TIMER CHECK option.
TIMER CHECK Wake up timer settings ( indicator is shown) Record timer settings TIMER CHECK (¶ indicator is shown)

ST-O5 FM 79.OOMHz

MD TAPE

After pressing ENTER, the display shows you the settings you�ve just made, including the switch on and off times, the station frequency, and the recorder(s) you�ll be using to record the broadcast. 8 Switch the system into standby mode before timer recording starts. The record timer indicator (¶) in the display indicates that the record timer is set. After the recording has finished, the record timer is automatically canceled. See the following section on Activating/deactivating the timers to cancel before recording, or to recall the timer settings after recording has finished. � If the wake up timer has been set, see the following section on Activating/deactivating the timers for limitations with using the timers concurrently. � After setting the timer, playback starts according to the most recent changes to the tape direction. � If the AC power is cut (blackout, accidentally unplugging the power cord), the system will return to the 12:00 clock display and both the timer and clock will have to be set again for the timer to work. � The timer won�t work if the clock isn�t set!

TIMER CHECK Both wake up ( ) and record timer (¶) settings * TIMER OFF Timer set to off (both and ¶ disappear)

* When the wake up and record timers are both set, make sure the end time of one timer does not overlap with the start time of the other. Leave at least a minute between the two settings (see below).
8:00 8:30 8:00 8:30

English

8:30

9:00

8:31

9:00

55
En