|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
;
This is a service manual in every sense of the word ( French and German versions of the text are included, as well as English..)
There are explanations of the mechanical and electrical functions, plenty of mechanical drawings, and the needed schematics. The quality of the scanning is excellent - all the component values are clearly legible - and very usefully there are pcb component layouts, so you can find a component on the schematic, and then very quicky pinpoint its physical location on the relevant pcb.
I cannot see how I can give this manual any less than the maximum 5 stars! Great value for money, which will pay for itself immediately. Excellent all round!
;
the manual is great and especially hard to find... thanks for the great service and having a hard to find manuel_
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.50 of store credit for Your review.
;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
5) Measure DC voltage at each test point with digital multi-meter, and adjust SFR. ADJ. ITEM G2 G0 BRT CONT COLOR(PAL) TINT ADJ. POINT SFR701 SFR702 SFR754 SFR751 SFR752 SFR731 TEST POINT G2 (TP1) G0 (TP2) BRT (TP3) CONT (TP4) ADJ. VALUE 1. 8 ± 0.05V 0.75 ± 0.05V 2.3 ± 0.05V 2.95 ± 0.05V
COLOR (TP5) 3.00 ± 0.05V TINT (TP6) 3.2 ± 0.05V
6) Observe the wave form at each test point with oscilloscope, and adjust SFR. ADJ. ITEM W-BAL (SBR) W-BAL (SBB) ADJ. POINT SFR705 SFR704 TEST POINT G (TP7)/ R (TP8) G (TP7)/ B (TP9) ADJ. VALUE ADJUST R (SFR705) AS SAME LEVEL TO G. (Fig.4) ADJUST B (SFR704) AS SAME LEVEL TO G (Fig.4)
0±0. 01V
G-LEVEL R-LEVEL & B-LEVEL
Fig. 4 W-BAL (SBR & SBB)
7) Push the PRGM key and select all RED picture signal on the LCD. Observe the wave form at the test point with osilloscope, and adjust LPF701 ADJ. ITEM PAL BURST ADJ. POINT LPF701 TEST POINT B (TP9) ADJ. VALUE ADJUST LPF701 AS SAME LEVEL. (Fig.5)
THIS WIDTH BECOMES NARROWEST
2.0 ± 0.1V GND Fig.5 PAL BURST
8) Turn the power off, and set SW102(NTSC/AUTO/PAL) to NTSC position. 9) Activate TEST MODE, and display the 11 STEP MONOTONE PICTURE. (Fig.2)
� 15 �
|
|
|
> |
|
