|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good reproduction (copy) of original manual. Didn't have a parts list, but schematic was completely labeled with parts. Complete instructions on how to adjust mechanical functions of the 8-track deck. Well worth having and at a very reasonable cost.
;
It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
;
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
;
It was complete service manual with all needed service informations. Thanks.
 ;
El manual esta muy detallado, los numeros de partes y los esquemas de despiece son correctísimos y muy claros, tanto para los técnicos experimentados como para los novatos.
What disc the IC has selected can be understood according to this judgment value. The decision standard of IC is as follows. 0 < Judgment value < 10 10 < Judgment value < 32 32 < Judgment value < C8 LCD displays �CD-d� No disc CD-RW CD-DA and CD-R LCD displays �CD-r� No disc No disc CD-RW CD-DA and CD-R
C8 < Judgment value The state of the FE waveform can also be understood from to this judgment. 3. Confirmation of Sled movement By pressing the F. SKIP of B. SKIP button continuously, it is possible to transfer the pick-up to either the outer side or inner side.
6. Confirmation of each servo It is possible to confirm the adjustment value of each servo by repeatedly pressing the MODE button while the disc is playing, The switchover, sequence is as stated below. Confirmation mode off � Focus Bias (FB) � Tracking Balance(TB) � Tracking Gain (TG) � Tracking Error Offset(TEO)� Focus Gain (FG) � Focus Error Offset (FEO) Confirmation mode off Example: Tracking Error Offset (TEO) Adjustment value: 03
4. Confirmation of the RF level Test point: RF and VC (Vref) Test disc: TCD-782 Confirm that the RF waveform as shown below.
more than 0.8Vp-p
VOL
VOLT/DIV: 200mV TIME/DIV: 0.5 s
Tracking Error Offset (TEO)display
Adjustment value
Adjustment value are displayed in HEX. 5. Confirmation of Tracking balance Test point: TE and VC (Vref) Test disc: TCD-782 Press the DSL button while the test disc playing and confirm the TE waveform is as is shown below.
A
VC
B
A:B = 1:1 VOLT/DIV: 200mV TIME/DIV: 2ms
15
|
|
|
> |
|
