|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
;
A site where discontinualed schematic diagrams and back dated information can be found on discontinued radios tv's and any electronic equipment can be found. Newer manuals either Service and operating manuals. Radio amateurs should find this site a great source for ham radio equipment manuals. I will return to this site should I need information on any electrical equipment. priced easy to download in a PDF format and print pages need to undertake the repair.
;
Quality scan of the original. All the detail necessary to troubleshoot, repair and adjust the unit. I'm sure I will be downloading more manuals in the future as the need arises.
;
Exactly as described, a Service Manual complete with the schematics and PCB layout delivered in a timely manner. Many thanks for the great service.
 ;
some of the writing is a bit blur but the part in the schmatic was great and i have fixed the machine thanks
XR-MT3
� Notes of procedure 3
.
8 9
Hang Carriage only here of Pinion.
,
9
FRONT side
7
Carriage 200 is lightly lifted by the finger.
7
When Carriage 100 drops below, Carriage 200 is lightly lifted by the finger. Note : Lift it horizontally when you lift Carriage. Carriage inclines when it is not the horizontal, and mechanism locks. Bevel Gear is turned clockwise (direction of a rear side from a front side) like the state of 7 . Carriage 200 lifts up. And, when the movement is started Carriage 100 to the direction of a front side, separates the hand which lifted Carriage 200.
8 9
4
Carriage 200
10 4-1 4-2
The other side of the side applied by pushed.
Keeps turning Bevel Gear clockwise (direction of a rear side from a front side) until Carriage 100 bumps to the wall on a front side.
3
of Carriage is lightly
Puts Carriage 100 on Carriage 200 which applies by Be careful about notes by 3 at this time.
4-1 .
5
Bevel Gear is turned clockwise. (direction of a rear side from a front side)
Carriage 100
5
11
The position of a right and left, black cam is matched while confirming it from the table side of Drawer. Surface of Drawer
6
6-1 6-2 6-3
Carriage 200 moves to a front side. Bevel Gear is turned as it is clockwise. (direction of a rear side from a front side) Carriage 100 drops below. Meanwhile, Mark of right and left, black Cam is matched.
11
Cam Mark
Cam Mark
51
|
|
|
> |
|
